Bunn-O-Matic came out with a different drip-brew machine. In this type of coffeemaker, the machine uses a holding tank or boiler pre-filled with water. When the machine is turned on, all of the water in the holding tank is brought to near boiling point (approximately 200–207 °F or 93–97 °C) using a thermostatically-controlled heating element. When water is poured into a top-mounted tray, it descends into a funnel and tube which delivers the cold water to the bottom of the boiler. The less-dense hot water in the boiler is displaced out of the tank and into a tube leading to the spray head, where it drips into a brew basket containing the ground coffee. The pourover, water displacement method of coffeemaking tends to produce brewed coffee at a much faster rate than standard drip designs. Its primary disadvantage is increased electricity consumption in order to preheat the water in the boiler. Additionally, the water displacement method is most efficient when used to brew coffee at the machine's maximum or near-maximum capacity, as typically found in restaurant or office usage. In 1963, Bunn introduced the first automatic coffee brewer, which connected to a waterline for an automatic water feed.
It also automatically pre-infuses the coffee, allowing the grounds to vent their CO2 and “bloom.” Remember, only half of the machines we tested had this feature, and it proved to pay off in our taste tests. The four machines we recommend all pre-infuse. Only one coffee maker without it, the Hamilton Beach, performed well at all in our taste tests — but that guy was so cheap and flimsy, part of the brew basket broke during our testing. Sorry, Hamilton Beach.
For example, if your coffee tastes a bit salty or sour, the grounds are under-extracted, which can be remedied by a finer grind. But what if only some of your grounds are too coarse, and others are too fine – and maybe some are just right? Having uniform grind size throughout your brew basket makes it easier to isolate and adjust this variable in order to get the level of extraction you want. The only way to achieve that is with a burr grinder. Miller — as well as a handful of our other experts — recommends the Barazata Encore Coffee Grinder ($129).
In France, in about 1710, the Infusion brewing process was introduced. This involved submersing the ground coffee, usually enclosed in a linen bag, in hot water and letting it steep or "infuse" until the desired strength brew was achieved. Nevertheless, throughout the 19th and even the early 20th centuries, it was considered adequate to add ground coffee to hot water in a pot or pan, boil it until it smelled right, and pour the brew into a cup.
The principle of a vacuum brewer was to heat water in a lower vessel until expansion forced the contents through a narrow tube into an upper vessel containing ground coffee. When the lower vessel was empty and sufficient brewing time had elapsed, the heat was removed and the resulting vacuum would draw the brewed coffee back through a strainer into the lower chamber, from which it could be decanted. The Bauhaus interpretation of this device can be seen in Gerhard Marcks' Sintrax coffee maker of 1925.
The principle of a vacuum brewer was to heat water in a lower vessel until expansion forced the contents through a narrow tube into an upper vessel containing ground coffee. When the lower vessel was empty and sufficient brewing time had elapsed, the heat was removed and the resulting vacuum would draw the brewed coffee back through a strainer into the lower chamber, from which it could be decanted. The Bauhaus interpretation of this device can be seen in Gerhard Marcks' Sintrax coffee maker of 1925.
For many of us, the daily grind can't begin until we've had that first cup of piping hot coffee—so the right brewer is at the top of the list. The most basic coffee makers make at least a decent cup, but a little more money buys conveniences such as programmability, a thermal carafe to keep coffee hot longer, settings that let you adjust brew strength, and more.
×